Firstly I needed to cut to approximate and a workable size. This I have made easier, by adding rails to my two saw-horses and making them into a panel cutter, I did this some time ago, but this is the first time they have seen action, and it made it so easy.
I stood the plywood panel in the rails, with the cutting line between the two saw-horses, measured my piece, then clamped my circular saw guide to the panel, and cut, couple of minutes, each was done.
Now I can cut the workable pieces to their exact measurements on the table saw, which hopefully I will have done this afternoon.
I have a slight problem at the moment, I damaged my left knee doing exercises the other day, and can not stand for too long, so that will be the decider. Learn from this experience...exercise is bad for your health!
No comments:
Post a comment
Comments are welcome, however to avoid abusive or inappropriate comments, some will be moderated, before they appear on the site.
Note: only a member of this blog may post a comment.