Saturday, 27 February 2016

Continuing the Router Table Fence

This morning, it was back into the workshop, and finish making the fence.

The first job was to cut and fit the supports, which as I mentioned previously was done with pocket holes.

That done, I made a hinged flap for the vacuum hook-up, disassembled the whole table,and gave all the working area a coat of varnish.

The table top, and the sliding fence faces have had two coats to provide a better surface for working timber.

That's it for today, I can't do any more until the varnish is 100% dry...Oh dear, what a shame! :)

No comments:

Post a comment

Comments are welcome, however to avoid abusive or inappropriate comments, some will be moderated, before they appear on the site.

Note: only a member of this blog may post a comment.